Page 2-13
Section 2. Configuration
PN 9001080
Rev. A
SATO M-8485Se Standard Print Engine
Service Manual
STEP PROCEDURE
4. Press the FEED key to accept the setting and advance the cursor to the
second digit. Again use the LINE key to step to the desired setting.
Once it is correct, press the FEED key to advance to the next
adjustment.
Print a test label after completing the adjustments to ensure it is
correct.
Pitch Offset Adjustment
A B C D E F G
A B C D E F G
A B C D E F G
Sensor Position
Line Feed Direction
Leading Edge of Label
Moved with negative (-)
offset to print on leading
edge of the label
Original (0 offset) first
line position
Moved with positive (+)
offset to print on trailing
edge of the label
To Next Page
Loading...
