SATO M-8485Se - Page 62

Page 2-44
Section 2. Configuration
PN 9001080
Rev. A
SATO M-8485Se Standard Print Engine
Service Manual
LCD Panel Printer—Label Out Sensor
STEP PROCEDURE
1. Record all current dip switch positions, then place all switches in the OFF
position.
2. Place the DSW2-4 in the ON or up position.
3. Press the FEED key while simultaneously turning ON the power switch. When
the printer beeps, release the keys. The following screens will appear.
4. Place the DSW2-4 in the OFF position and the following screen will appear.
5. Press the LINE key to select YES or NO, then press the FEED key and the
following screen will appear.
label out sensor
yes no
initializing
rom v00.00.00.00
label out sensor
label out sensor
completed