To reinstall the bucket seats, do the following:
1. With the seat folded, squeeze the angled bar
beneath the seat toward the straight crossbar, while
placing the front hooks of the seat into the front
two floor pins.
2. Make sure the seat is
angled so that the front
seat hooks clear the
floor pins. If the
front hooks are not
attached correctly, the
seat’s rear hooks
will not attach to the
rear set of floor pins.
If the front hooks are not attaching correctly, check
that the seat is in the full rear position.
3. Firmly push the rear seat hooks into the rear floor
pins by pushing down the rear of the seat.
{CAUTION:
A seat that is not locked into place properly
can move around in a collision or sudden stop.
People in the vehicle could be injured. Be sure
to lock the seat into place properly when
installing it.
1-13
To Next Page
Loading...
