Dinghy Towing
When dinghy towing, the vehicle should be run at
the beginning of each day and at each RV fuel
stop for about five minutes. This will ensure proper
lubrication of transmission components.
You may dinghy tow your vehicle from the front
following these steps:
1. Position the vehicle to tow and then secure it.
2. Turn the ignition to OFF.
3. Set the parking brake.
4. To prevent the battery from draining while the
vehicle is being towed, remove the following
fuse from the instrument panel fuse block:
(IGN SENSOR). See Instrument Panel Fuse
Block on page 393 for more information.
5. Turn the ignition key to ACC.
6. Shift your transmission to NEUTRAL (N).
7. Release the parking brake.
Remember to reinstall the IGN SENSOR fuse
once you have reached your destination.
Notice: If you exceed 65 mph (105 km/h) while
towing your vehicle, it could be damaged.
Never exceed 65 mph (105 km/h) while towing
your vehicle.
285
To Next Page
Loading...
Need help?
General
