When the shoulder belt is pulled out all the
way, it will lock. If it does, let it go back all the
way and start again.
If the belt is not long enough, see Safety Belt
Extender on page 39.
Make sure the release button on the buckle is
positioned so you would be able to unbuckle
the safety belt quickly if you ever had to.
3. To make the lap part tight, pull up on the
shoulder part.
The lap part of the belt should be worn low
and snug on the hips, just touching the thighs.
In a crash, this applies force to the strong
pelvic bones. And you would be less likely to
slide under the lap belt. If you slid under it,
the belt would apply force at your abdomen.
This could cause serious or even fatal injuries.
34
To Next Page
Loading...
Need help?
General
