Turn Signal/Multifunction Lever
The lever on the left side of the steering column
includes the following:
• G Turn and Lane-Change Signals. See Turn and
Lane-Change Signals on page 3-7.
• 53 Headlamp High/Low-Beam Changer. See
Headlamp High/Low-Beam Changer on page 3-8.
• Flash-to-Pass. See Flash-to-Pass on page 3-8.
• O Exterior Lamp Control. See Headlamps
on page 3-13.
Turn and Lane-Change Signals
The turn signal has two upward (for right) and
two downward (for left) positions. These positions
let you signal a turn or a lane change.
To signal a turn, move the lever all the way up or down.
When the turn is finished, the lever returns automatically
to the normal position.
An arrow on the instrument
panel cluster flashes in
the direction of the turn or
lane change.
To signal a lane change, raise or lower the lever until
the arrow starts to flash. Hold it there until you complete
your lane change. The lever returns by itself when it
is released.
If the arrows flash rapidly or do not go on at all as you
signal a turn or lane change, a signal bulb could be
burned out and other drivers will not see your turn signal.
Replace burned out bulbs to help avoid an accident.
Also, check the appropriate fuses. See Fuses on
page 5-87.
3-7
To Next Page
Loading...
