The tire valve stem must be positioned between the
3 and 9 o’clock positions.
4. Remove the valve stem cap from the flat tire by
turning it counterclockwise.
5. Attach the sealant/air hose (F) onto the tire valve
stem. Turn it clockwise until it is tight.
6. Unwrap and plug the air compressor accessory
plug (E) into an accessory power outlet in the
vehicle. See Accessory Power Outlet(s) on
page 3-21.
{ CAUTION:
Overinflation could cause the tire to rupture,
and you or others could be injured. Be sure to
read the inflator instructions, and inflate the
tire to its recommended pressure. Do not
exceed 35 psi (248 kPa).
7. Start the vehicle. See Starting the Engine on
page 2-27. The vehicle must be running while using
the air compressor.
{ CAUTION:
Overinflation could cause the tire to rupture,
and you or others could be injured. Be sure to
read the inflator instructions, and inflate the
tire to its recommended pressure. Do not
exceed 36 psi (248 kPa).
8. Turn the selector switch (A) counterclockwise to the
sealant and air position.
5-77
To Next Page
Loading...
