2. Turn the lug wrench counterclockwise until
approximately 6 inches (15 cm) of cable is exposed.
3. Attach the lug wrench to the jack and raise the jack
at least 10 turns.
4. Place the jack under the vehicle, ahead of the rear
bumper. Position the center lift point of the jack
under the center of the spare tire.
5. Turn the lug wrench clockwise to raise the jack until
it lifts the secondary latch spring.
6. Keep raising the jack until the spare tire stops
moving upward and is held firmly in place. This lets
you know that the secondary latch has released and
the spare tire is balancing on the jack.
7. Lower the jack by turning the lug wrench
counterclockwise. Keep lowering the jack until
the spare tire slides off the jack.
All-Wheel-Drive Vehicle shown
5-94
To Next Page
Loading...
Need help?
General
