Gas Range Manual Page 10 Revision: 24 Feb 2011
SPECIFICATIONS
INSTALLATION
THIS EQUIPMENT MUST BE INSTALLED BY AN
AUTHORIZED PERSON IN ACCORDANCE WITH LOCAL GAS
SAFETY CODE, LOCAL AUTHORITY, GAS, ELECTRICITY,
ANY APPLICABLE STATUTORY REGULATIONS AND
MANUFACTURER REQUIREMENTS.
NOTE: INSTALLATION IS THE RESPONSIBILITY OF THE OWNER
Gas Inlet Connection: 3/4” NPT Female.
Gas Connection Point: For Range units, the gas connection point is
located at the rear of the unit 810 mm (32”) above
the floor and 45 mm (1.8”) from the right hand side
Gas Connection: Prescribed requirements include, commission the
equipment, gas leakage testing, operational
checking and adjustments.
All units are tested and adjusted at the factory; however, burners and pilots
must be checked at the installed location and adjusted if necessary.
Model
Top
Burners Qty
Oven
Qty
Product
breadth
(inch/mm)
Product
depth
(inch/mm)
Product
height
(Inch/mm)
SMDR-36-6 6 1 36 / 916 33 / 840 59 / 1495
To Next Page
Loading...