å
Carefully turn your unit over onto its front edges. Lay the
BACK (H) over your unit.
å
Make equal margins along all four edges of the BACK (H).
Push on opposite corners of your unit if needed to make
it "square".
å
Fasten the BACK (H) to your unit using the NAILS (1N).
Step 13
NAIL
(14 used in this step)
1N
H
408995 www.sauder.com/servicesPage 18
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
Caution
To Next Page
Loading...
