å
Carefully turn your unit over onto its front edges. Unfold the LARGE
BACK (H) and lay it over your unit.
å
Make equal margins along all four edges of the LARGE BACK (H).
Push on opposite corners of your unit if needed to make it "square".
å
Fasten the LARGE BACK (H) to your unit using the NAILS (AA). The
NAILS should be 5-1/2" apart, 1-1/2" from the corners, and 1/4" in
from the edges. Also, be sure the NAILS are 1/2" from each fold
line in the BACK.
å
Repeat this step for the BACK (I).
Step 11
410367www.sauder.com/services
Page 15
1/4"
5-1/2"
1-1/2"
1"
1/2"
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
Caution
Unfi nished
surface
Unfi nished
surface
H
I
Do not fasten NAILS along this edge until the
BACK (I) is overlapping the LARGE BACK (H).
NAIL
(55 used in this step)
AA
To Next Page
Loading...
