Sauder 411802 - Page 17

Step Step 12
Page 17
å
Pull the DRAWER FRONT BRACKETS (9G) apart and slide them into
the grooves in the DRAWER SIDES (D50 and D51). You may need to
gently tap them in with a hammer.
å
NOTE: The DRAWER FRONT BRACKETS are marked "RH" and "LH"
for easy identifi cation.
å
Fasten the DRAWER FRONT (L) to the DRAWER FRONT
BRACKETS (9G). Use four BLACK 9/16" LARGE HEAD SCREWS (1S).
å
Slide the DRAWER BOTTOM (D983) into the grooves in the
DRAWER SIDES (D50 and D51) and DRAWER FRONT (L).
L
9G
9G
L
With the palm of your hand,
tap the DRAWER BOTTOM
down into the groove.
Groove
Unfi nished surface
9G
1
st
2
nd
BLACK 9/16" LARGE HEAD SCREW
(4 used in this step)
1S
D51
D983
D51
D50
D50
VIEW THE T-SLOT BOX VIDEO