Sauder 411985 - Step 2: Attach Ends and Molding

Step 2
å
Fasten the ENDS (A2 and B2) to the TOP (C2). Tighten
four TWIST-LOCK® FASTENERS.
å
Fasten the TOP MOLDING (J) to the TOP (C2). Tighten
two TWIST-LOCK® FASTENERS.
411985 www.sauder.com/servicesPage 6
B2
Edge with
TWIST-LOCK®
FASTENERS
C2
A2
J
Dowel end
Long fi nished edge
Wide edge
Finished surface
Long fi nished edge
Surface with holes
Surface without holes
Remember:
Righty tighty.
Lefty loosey.
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
Caution
How to use the SAUDER TWIST-LOCK
®
FASTENER
1. Insert the dowel end of the FASTENER into the
hole of the adjoining part.
NOTE: The dowel end of the FASTENER must
remain fully inserted in the hole of the adjoining
part while locking the FASTENER.
2. Tighten the FASTENER with a Phillips
screwdriver as tight as possible.