Sauder 411985 - Step 4: Attach Feet and Skirts

Step 4
å
Slide the FEET (31E and 32E) into the notches in the SKIRTS (H and R).
å
Use a hammer to drive a PROPEL NUT (14M) into the holes in the FEET (31E and 32E). Now, turn an ADJUSTABLE
GLIDE (18E) completely into each PROPEL NUT.
å
Fasten the SKIRTS (H and R) to the BOTTOM (D2). Use four BLACK 9/16" WAFER HEAD SCREWS (33S) through the
FEET and into the BOTTOM.
å
NOTE: Start all screws a few turns before tightening any of them. Use the exact holes shown in the FEET (32E).
H
R
R
32E
31E
32E
31E
18E
14M
(4 used)
411985 www.sauder.com/servicesPage 8
H
R
R
D2
BLACK 9/16" WAFER HEAD SCREW
(4 used in this step)
33S