411985www.sauder.com/services
Page 9
Step Step 5
E2
å
Carefully turn your unit over onto its front edges. Unfold
the BACK (E2) and lay it over your unit.
å
A hole in the BACK (E2) has been provided for access
to the SAFETY STRAP (60M). Push the SAFETY STRAP
through the hole.
å
Make equal margins along all four edges of the
BACK (E2). Push on opposite corners of your unit if needed
to make it "square".
å
Fasten the BACK (E2) to your unit using the NAILS (1N).
NAIL
(40 used in this step)
1N
60M
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
Caution
To Next Page
Loading...
