Sauder 413322 - Assembly Step 2: Attaching the Back Panel; Safety Precaution for Back Panel

Step 2
413322 www.sauder.com/servicesPage 6
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
Caution
Unfi nished
surface
NAIL
(25 used in this step)
I
C
å
Unfold the BACK (C) and lay it over your unit.
å
Make equal margins along all four edges of the BACK (C).
Push on opposite corners of your unit if needed to make
it "square".
å
Fasten the BACK (C) to your unit using the NAILS (I). The
NAILS should be 5-1/2" apart, 1-1/2" from the corners,
and 1/4" in from the edges.
1/4"
5-1/2"
1-1/2"