Sauder 413852 - Page 15

å
Fasten the SLATS (J2) to the UPPER FRONT PANEL (G2)
and BACK PANEL (I2). Use twelve SILVER 1-1/8" FLAT
HEAD SCREWS (10S).
å
Fasten the BOTTOM SUPPORTS (B2) to the
HEADBOARD (E) and FOOTBOARD (F). Use eight
SILVER 1-1/8" FLAT HEAD SCREWS (10S).
å
Insert a METAL PIN (1R) into each HEADBOARD (E) and
FOOTBOARD (F).
Step 11
413852www.sauder.com/service
Page 15
Rounded edge
SILVER 1-1/8" FLAT HEAD SCREW
(20 used in this step)
10S
Edge without holes
B2
J2
B2
J2
I2
G2
J2
J2
F
E
Edge without holes
Edge without holes
1R
1R