Step 8
å
Insert four METAL PINS (1R) into the holes in the edges of
the UPRIGHTS (H).
å
Fasten the TOP (E) to the MOLDINGS (I, J, and K). Use
eight SILVER 1-1/8" FLAT HEAD SCREWS (10S).
å
NOTE: Start each SCREW a few turns before completely
tightening any of them. Do not overtighten.
å
NOTE: Be sure the METAL PINS in the UPRIGHTS insert
into the TOP.
418630 www.sauder.com/servicesPage 12
1R
SILVER 1-1/8" FLAT HEAD SCREW
(8 used in this step)
10S
(4 used)
H
H
E
I
Long rounded edge
K
J
Surface
with
holes
To Next Page
Loading...
