å
Carefully turn your unit over onto its front edges. Lay the
BACK (G) over your unit.
å
Make equal margins along all four edges of the BACK (G).
Push on opposite corners of your unit if needed to make
it "square".
å
Fasten the BACK (G) to your unit using the NAILS (1N).
å
NOTE: Be sure to tap NAILS into the holes that line up
over both UPRIGHTS (H).
å
NOTE: Perforations have been provided for access
through the BACK. Carefully cut out the holes needed.
Step 9
418630www.sauder.com/services
Page 13
Unfi nished surface
These holes must line up
over the UPRIGHTS (H).
NAIL
(32 used in this step)
1N
G
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
Caution
To Next Page
Loading...
