Sauder 423032 - Step 7: Securing the Back Panel

å
Carefully turn your unit over onto its front edges. Unfold
the BACK (H2) and lay it over your unit.
å
A perforation in the BACK (H2) has been provided for
access to the SAFETY STRAP (60M). Punch out the
perforation and push the SAFETY STRAP through the hole.
å
Make equal margins along all four edges of the BACK (H2).
Push on opposite corners of your unit if needed to make
it "square".
å
Fasten the BACK (H2) to your unit using the NAILS (1N).
The NAILS should be 5" apart and 1/4" in from the edges.
Step 7
423032www.sauder.com/services
Page 11
1/4"
5"
NAIL
(30 used in this step)
1N
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
Caution
H2
Unfi nished
surface
Before fastening the
BACK, punch out the
perforation and push
the SAFETY STRAP
through the hole.
60M