Step 8
Page 12
å
Carefully turn your unit over onto its front edges. Unfold
the BACK (S) and lay it over your unit.
å
Make equal margins along all four edges of the BACK (S).
Push on opposite corners of your unit if needed to make
it "square".
å
Using your hammer, fasten the BACK (S) to your unit
using the NAILS (31).
å
NOTE: Be sure to tap NAILS into the holes that line up
over the UPRIGHT (O).
å
Peel the backing o of each FELT DISC (32) and stick
them on the edge of the ENDS (M and N).
å
NOTE: Be sure the FELT DISCS are placed approximately
1/8" in from the front edge of the ENDS.
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
Caution
NAIL
(36 used in this step)
S
Unfi nished
surface
These holes must line up
over the UPRIGHT (O).
32
M
N
This FELT DISC should set in 1/8"
from the front edge of the ENDS.
This FELT DISC should set in 1/8"
from the front edge of the ENDS.
31
To Next Page
Loading...
