Step 5
å
Separate the EXTENSION SLIDES (BB) from the EXTENSION RAILS (AA) as
shown in the upper diagram below. Be prepared, the parts are greasy.
å
Fasten the EXTENSION RAILS (AA) to the EXTENSON BLOCKS (I) on the
ENDS (A2 and B2) and UPRIGHTS (C2 and D2). Use eight GOLD 5/16"
FLAT HEAD SCREWS (3S).
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in
the enlarged diagram. Then, slide the inner cartridge of the EXTENSION
RAIL out to fi nd the other hole that lines up with the hole in the END. Turn a
SCREW into this hole.
408289 www.sauder.com/servicesPage 10
Open end
Open end
Open end
Open end
A2
B2
C2
D2
AA
AA
AA
AA
Hole
AABB
Push the black lever in and pull the SLIDE from the RAIL.
GOLD 5/16" FLAT HEAD SCREW
(8 used in this step)
3S
I
I
I
I
To Next Page