Step 7
å
Insert four METAL PINS (1R) into the BRACES (H2).
å
Insert the METAL PINS (1R) in the ends of two BRACES (H2)
into the holes in the LEFT END (B2) and LEFT UPRIGHT (C2).
å
Fasten two BRACES (H2) to the LEFT END (B2) and LEFT
UPRIGHT (C2). Tighten four HIDDEN CAMS.
å
Repeat this step for the RIGHT END (A2), RIGHT
UPRIGHT (D2), and remaining BRACES (H2).
408289 www.sauder.com/servicesPage 12
(8 used)
1R
B2
C2
Surface with
HIDDEN CAMS
Surface with
HIDDEN CAMS
Surface without
HIDDEN CAMS
Surface with
HIDDEN CAMS
Edge with
HIDDEN CAMS
Edge with
HIDDEN CAMS
Edge with
HIDDEN CAMS
Edge without
HIDDEN CAMS
Start Tighten
Arrow
Minimum
190 degrees
Caution
Risk of damage or
injury. HIDDEN CAMS
must be completely
tightened. HIDDEN
CAMS that are not
completely tightened
may loosen, and parts
may separate. To
completely tighten:
Arrow
Maximum
210 degrees
H2
H2
To Next Page