Sauder Executive Desk 408289 - Product Assembly Essentials; Assembly Tools Required; Part Identification Guide

Table of Contents Assembly Tools Required
2-3
4-5
6-27
28-31
32-36
37-38
39
Part Identifi cation
Hardware Identifi cation
Assembly Steps
Français
Español
Safety
Warranty
Hammer
Not actual size
No. 2 Phillips Screwdriver
Tip Shown Actual Size
408289 www.sauder.com/servicesPage 2
Part Identifi cation
å While not all parts are labeled, some of the parts will have a label or an inked letter on the edge
to help distinguish similar parts from each other. Use this part identifi cation to help identify similar parts.
A2 RIGHT END (1)
B2 LEFT END (1)
C2 LEFT UPRIGHT (1)
D2 RIGHT UPRIGHT (1)
D78 LARGE DRAWER BACK (2)
D87 LARGE RIGHT DRAWER SIDE (2)
D88 LARGE LEFT DRAWER SIDE (2)
D107 RIGHT DRAWER SIDE (4)
D108 LEFT DRAWER SIDE (4)
D109 DRAWER BACK (4)
D707 DRAWER BOTTOM (4)
D708 LARGE DRAWER BOTTOM (2)
E2 TOP (1)
F2 MODESTY PANEL (1)
G2 BACK (2)
H2 BRACE (4)
I EXTENSION BLOCK (4)
J BASE (4)
K KEYBOARD FRONT (1)
L KEYOARD BACK (1)
LLL LEFT KEYBOARD SIDE (1)
M2 RIGHT KEYBOARD SIDE (1)
N2 KEYBOARD SHELF (1)
O DRAWER FRONT (4)
T LARGE DRAWER FRONT (2)
Y BOTTOM MOLDING (4)
Z END MOLDING (4)