Sauder Harbor View 417586 - Page 20

å
Lay the remaining BACK (K) over DOOR ENDS (A and B),
and BRACE (L).
å
Make equal margins along all three edges of the
BACK (K). Push on opposite corners of your unit if needed
to make it "square".
å
Fasten the BACK (K) to your unit using the NAILS (1N).
å
NOTE: Perforations have been provided for access
through the BACK. Carefully cut out the rectangle in the
BACK for proper ventilation of your CPU.
Step 14
NAIL
(15 used in this step)
1N
Edge without holes
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
Caution
Finished
surface
K
417586 www.sauder.com/servicePage 20