Sauder Lateral File - Page 15

Step 11
Fill the holes 1/4 to 1/2 full with GLUE.
Inspect the parts thorouhly before
assemblin. Disassembly of lued
parts is extremely di cult.
Caution
!
54M
54M
B
How to use the SAUDER TWIST-LOCK
®
FASTENER
1. Insert the dowel end of the FASTENER into the hole of the
adjoinin part.
NOTE: The dowel end of the FASTENER must remain fully
inserted in the hole of the adjoinin part while lockin
the FASTENER.
2. Tihten the FASTENER with a Phillips screwdriver as tiht
as possible.
Dowel end
K
å
Fill the holes in the TOP (K) 1/4 to 1/2 full with GLUE (54M).
å
Fasten the LEFT END (B) to the TOP (K). Tihten two TWIST-LOCK®
FASTENERS. Wipe away the excess lue.
å
NOTE: Be sure the WOOD DOWELS in the LEGS insert into the holes in
the TOP.
This roove
must be here.
420040www.sauder.com/services
Pae 15
Meet Part (K). This component has
been enineered to be lihter, stroner,
faster… well ok. Not technically faster.
But defi nitely makes for a sturdier
Lateral File that’s easier to assemble
and friendlier to the environment.