Version 1.0
[ 71 ]
SAV 220.76 /SAV 242.92 /SAV 243.70 /.71 /
SAV 243.72 /.73 /.76 /.77 /.78 /.79 /.80 /.99
Version 1.0
[ 71 ]
EN
SAV 220.76 /SAV 242.92 /SAV 243.70 /.71 /
SAV 243.72 /.73 /.76 /.77 /.78 /.79 /.80 /.99
8 TROUBLESHOOTING
8. TROUBLESHOOTING
The safety information from section 2 “Safety” must be observed.
DANGER!
Hazard from malfunction!
Incorrect assembly of the magnetic chuck can cause a malfunction of the
machine.
This can cause crushing and jamming points, posing a risk of crushing for
limbs.
Objects can be ejected, causing serious injuries and even death.
■
Have troubleshooting carried out only be qualified personnel.
■
The magnetic chuck must always be securely attached to the work
surface of the machine tool. Check after assembly!
■
Re-attach safety devices correctly.
DANGER!
Risk of crushing!
There is a risk of limbs being crushed by the magnetic chucks tipping over
or falling due to incorrect installation and removal of the magnetic circular
chucks.
■
Secure the magnetic chucks against falling or tipping over.
■
When lifting the magnetic chucks, only use suitable and approved
lifting gear and slings which are designed for the weight of the magnetic
circular chucks.
■
Have troubleshooting carried out only be qualified personnel.
DANGER!
Risk of electric shock!
The magnetic holding force is switched on and off with current pulses.
Electro permanent magnetic chucks use high magnetising and demagnetising
voltages. An electric shock can result in death or serious injuries.
■
Before troubleshooting, always disconnect the electro permanent magnetic
chucks from the power supply.
■
Always protect the junction box and rubberised cable against damage.
■
To exclude malfunctions and hazards for the operator, it must be ensured
that the junction box is sealed, in particular during wet work and after
any repair work. The same applies to any connectors.
■
If the magnet has a connector, only unplug this once the demagnetising
cycles has been completed and the red signal light is permanently on.
Risk from electric arc.
To Next Page
