Need help?Do you have a question about the Sav 876.02-SE2-2 and is the answer not in the manual?
Dangers of incorrect use of the electronic control-unit, emphasizing its importance for operator safety.
Specifies correct usage of the polarity reversing control-unit with SAV magnetic chucks and proper selection.
Details hazards associated with high direct and alternating currents, stressing necessary precautions before maintenance.
Defines requirements for operators to be properly trained and responsible for safety in the working area.
Describes the operator's designated workplace and necessary electronic disconnection for setup and startup.
Outlines requirements for protecting the control unit from environmental factors like splash water, steam, dust, and chips.
Explains the shock-proof design and how the control unit saves its state and provides holding force after voltage drops.
Presents technical electrical details and dimensional data for various models of control units and magnetic chucks.
Provides instructions for mounting the control unit and connecting it to the magnetic chuck, power supply, and control systems.
Details the procedure for positioning work pieces using the reduced holding force setting of the magnetic chuck.
Explains how to perform machining operations with the magnetic chuck engaged at its full holding force.
Describes the process for safely unloading work pieces and demagnetizing the magnetic chuck after operation.
Lists the manufacturer's declaration of conformity with relevant European Laws and applied technical standards.
Details the product guarantee period, limitations, and specific conditions excluded from coverage.
General| Product type | Control unit |
|---|---|
| Analog inputs | 2 |
| Analog outputs | 2 |
| Communication | RS-485 |
| Model | 876.02-SE2-2 |
To Next Page
