| Install batteries
Slide off the cover case of the
battery room, and put into 2
AAA batteries. Then slide the
cover case back.
| Setting capacity
and timing
I®
DISPLAY
RESET
Keep pressing |
button, then press |
button and release both of the buttons. The DigiFlow
8000T will go into setting procedure. The digit will flash
to notice you that the setting procedure is on.
> Setting capacity
Press IW M ilia fl button to choose the
capacity. The sequence is 0 - 100 -
200 - 300...9800 - 9900 - OFF - 0 -
100. Then press is ia a a a button to save
the filter capacity value. Then go into
timing setting.
*The capacity mode will be disabled when you choose OFF.
» Setting timing
Press lilb ld fe V l button to choose the timing.The
sequence is 0 - 30 - 60 - 90...690 - 720 - OFF - 0 - 30.
Then press to save the Timing. The setting
procedure is completed.
*The capacity mode will be disabled when you choose OFF.
*The setting procedure will be terminated, and go back to
To Next Page
Need help?
General
