3.2. Specifications
32° to 104° F (0° to 40° C)
10% to 80% Relative Humidity (non-condensing)
5 cubic feet per minute (CFM) recommended.
100-240V AC, 50/60 Hz 1.5 Amp
(uses standard 3 prong IEC C14 connector)
Total Harmonic Distortion+Noise
(THD+N)
< 0.004 %, 20 Hz - 20 KHz
Signal-to-Noise Ratio (SNR)
20 Hz - 20 kHz ( varies +/- 1.5 dB over this range)
Volume Control per Channel
+ 10 dB to -117 dB in 0.5 dB increments
-10dB to +10dB on every configured audio input
Individual output channel mute when in processed mode.
Configurable on every output pair. Each channel will output the combined
input signal.
Seven-Band Equalizer (EQ)
On a per channel basis; +/- 12 dB, 0.5 dB steps
44.1 kHz | 48 kHz | 96 kHz @ 16-bit or 24-bit resolution
Output Delay Each Channel
(SSA-3220D Only)
Adjustable from 0 to 85ms
FCC Part 15 | S Mark | CE Mark | C-Tick
Supported Audio Output Formats
Supported Audio Output Formats
Audio Output Connector Type
16 Analog Stereo PCM Inputs
16 stereo outputs with RCA jack connectors, left and right
S/PDIF Inputs: 16 Digital Coax
or 12 TosLink
—Select between Coax or
TosLink (first 12 inputs)
S/PDIF outputs: Four digital coax outputs RCA jack connectors;
Coax output level: 500 mV nominal into 75 ohms
—Individually selectable pass-through for each digital input
Note: A 2ch PCM signal is required in order for a digital source to use
pass-through.
Converts Stereo Analog Audio to two-channel PCM S/PDIF (Coax only) or
converts PCM S/PDIF Audio (Coax or TosLink) to Stereo Analog audio.
Minimum Supported Release:
Minimum Supported Release:
Savant
®
SmartAudio Matrix Switch Blueprint Deployment Guide
Savant
®
SmartAudio Matrix Switch Blueprint Deployment Guide
Savant
®
SmartAudio Matrix Switch Blueprint Deployment Guide
Savant
®
SmartAudio Matrix Switch Blueprint Deployment Guide
Savant
®
SmartAudio Matrix Switch Blueprint Deployment Guide
Savant
®
SmartAudio Matrix Switch Blueprint Deployment Guide
To Next Page
Loading...
Need help?
General
