PERIODIC CLEANING
POWER WASHING
HARDER TO CLEAN AREAS
Congratulations on purchasing your Savoy
Timber composite balustrade. To ensure that
you keep your low-maintenance balustrade
looking its best, we recommend following a few
easy guidelines.
For periodic cleaning, use a soft bristle brush
and a dilution of mild soap and warm water.
For those using a power washer, we
recommend that you stand at least one metre
away from the area you are cleaning. Spray in
the direction of the grain to avoid damaging the
decking. Always follow the safety precautions
when operating a power washer.
For those areas that are harder to clean or where
the balustrade may have been damaged, we
recommend using 400-grit sandpaper. Lightly sand
the balustrade in the same direction as the grain.
Rinse thoroughly with water after sanding.
All supporting structures must be in accordance with applicable building codes. If. If in doubt, please consult your
local authority and ensure compliance prior to installation. Local building code requirements will always supersede
any suggested procedures and measurements in the following installation. The following installation instructions
are intended as a general guideline based on common building practices used in balustrade installations.
Savoy Timber’s balustrade is not intended for use as columns, support posts, beams, joist stringers, or other
primary load-bearing members.
BALUSTRADE
MAINTENANCE GUIDE
AT LEAST 1M DISTANCE
400 GRIT
SANDPAPER
To Next Page
Loading...