Service Procedure SP-JSS-190516-001
Steps to Replace Job Site Saw Arbor Belt or Motor
Page 1 of 10
Tools & Supplies Required for This Procedure:
• #2 Phillips Head Screwdriver
• 5mm Allen Wrench
• 13mm Wrench
• Blade Wrench
• SawStop Part #JSS-238
Procedure Steps:
(Before starting, please read instructions all the way through to ensure complete understanding)
To ensure safety, disconnect all electrical power to the saw.
1. Tilt the saw to 45 degrees.
To Next Page
Need help?
General