9
GENERAL CLEANING
It is recommended to clean daily or after every use.
Always disconnect the power cord from the mains socket before cleaning.
Avoid all risk of electric shock by not cleaning the
appliance with water and do not immerse it in water.
Do not use abrasive solutions or concentrated
detergents.
• Clean the exterior with a soft cloth or slightly damp cloth.
• After use, make sure that all parts are completely dry.
Head (2) removal and blade cleaning - Figure B
• Check that the appliance is off and disconnect it from the power mains.
• Lift the head with force to disengage it.
• To clean the blade (6/7), use the appropriate brush supplied (10 g. A).
• To reinsert the head, press it downwards engaging both sides.
The head foil (1) is very delicate: take care not to damage it
during cleaning. We recommend gently releasing it from the
head, blowing on it or cleaning it with soap and water. Check
that the foil is completely dry before reinserting it into the head.
Take care not to drop the head (Fig. D/E).
Replacing the blade - Figure C
• Check that the appliance is off and disconnect it from the power mains.
• Remove the head as shown in the previous paragraph.
• Gently grasp the blade (6/7) from both sides and pull upwards to
disengage it from the support (12) (not visible in the figure).
• Grasp the new blade from both sides and insert the central pin
(13)
into its support
(12)
and push downwards firmly until it snaps into
To Next Page
Loading...