■ If the login prompt is still not shown press ctrl+alt+F1
to change the screen output.
■ NOTE: In general, the following commands leading with a
sudo will ask for a password. Use the same password as
the node login.
■ Enter the command to configure the node IP and then fill in
the information as prompted, hitting enter to finalize each IP
assignment.
■ A single node system:
■ sudo scnodeinit
■ LAN IP
■ LAN Netmask
■ LAN Gateway
■ Backplane IP of this node
■ Backplane IP of the first node in the
cluster
■ This field is a special case and as
there is only one node should use
the same IP as the “Backplane IP
of this node” field.
■ A 3+ node system
■ sudo scnodeinit
■ LAN IP
■ LAN Netmask
■ LAN Gateway
■ Backplane IP of this node
To Next Page
Loading...
