Name: Scaletron 2350
Brand: Scaletron
Rating: 5 (1 reviews)

To Next Page

To Previous Page

Model 2330, Model 2350, Model 2352, Model 2353, Model 3001, Model 3002, Model 3003, Model 3004, Model 3005, Model 3006, Model 4010, Model

4020, Model 4021, Model 4030, Model 4040, Model 4041, Model 5305, and Pro-Gram Guide are trademarks of Scaletron Industries Ltd. Total

7. To complete calibration of 4-20mA output, adjust R-19 for proper 20 mA adjustment

reading. Factory setting is for 20 mA at 150.0 lb (68 kg.) unless specified otherwise.

8. Calibration is complete if specified accuracy is obtained. Repeat for second half of scale.

VI. Troubleshooting:

1. If Display reads “-1”:

A. Gross under load, turn tare knob clockwise. Numbers should reappear and can be

adjusted to tare weight or zero as required.

B. Check load cell connections at indicator and connect wires per chart on page 2

2. If Display reads “1”:

A. Gross overload, if starting point was zero, the cylinder weight is more than 199.9 lbs.,

or kg.

B. If starting point was -150 lbs. (68 kg.) then the cylinder weight is more than 349.9

lbs. (158 kg.) Remove weight and recheck tare setting.

C. Check load cell connections according to page 2, Step 4

3. If No Display:

A. Check power to weigh meter.

B. Check green light on power supply board. It should be lit. If not lit, it is shorted out.

4. Other problems: (PLEASE HAVE SERIAL NUMBER OF SCALE WHEN CALLING)

A. Consult factory:

USA & Canada Toll-Free: (800) 257-5911

Tel: (+1) 215-766-2670 ♦ Fax: (+1) 215-766-2672

Notice: Do not return any equipment without first contacting the factory. A return

authorization number will be issued and it must be marked on all materials returned to the

factory, accompanying a letter that explains the problem specifically. A Serial Number will

also be required. It is located inside the indicator box.

Scaletron 2350 User Manual

Questions and Answers: