EasyManua.ls Logo

Scanivalve DSA5000 User Manual

Default Icon
2 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
DSA5000 Quick Start Guide
Step 1: Unpack & Inventory
When you rst unpack the DSA5000, begin by inspecng
and inventorying the contents of the package. If any visible
damage is immediately noced or if any contents are miss-
ing, contact Scanivalve before proceeding. Modules ship
standard with:
1) DSA5000 Module
2) DSA5000 Accessory Kit
3) Cercate of Calibraon
4) DSA Resource Disk (USB Drive)
There may be other cabling or accessories included with
your order. Fings may or may not be installed on the
module at me of shipment.
Step 2: Connect Ethernet Cable
Connect a DSA Ethernet cable to the DSA Ethernet port. The
cable will thread into the connector.
If no DSA5000 Ethernet cable was purchased, the DSA5000
accessory kit will include a Ethernet mang connector that
can be used to fabricate an Ethernet cable and connecon.
Step 3: Connect Ethernet Cable
Connect a DSA power cable to the DSA power port. The
cable will thread into the connector.
If an AC to DC power supply is provided (PDM series), con-
nect the power cable before powering on the power supply.
If no power supply or power cable is supplied, the DSA5000
accessory kit will include a power mang connector that can
be used to fabricate a power connecon. This cable can be
connected to a compable DC power supply (9 to 36VDC @
12W). See the wiring diagram on the right for lead connec-
ons (Red and Black).
CAUTION! Do not make or
break the power connector
with power applied! Doing so
risks damage to the module.
Once all connecons are made, apply power to the DSA and
allow the module enough me to boot. The Power, Link and
Status lights should all light.
Step 4: Setup the Host Computer
DSA5000 and Standard Accessories
DSA5000 Cable Connections
to DC Powerto Ethernet
1 NI P
2 NI P
3 NI P
4 NI P
5 NI P
6 NI P
7 NI P
8 NI P
) E R A B ( D NG S I S S A H C
) K L B ( DNG
) GRO ( DNG
) T HW ( N I V +
) DE R ( N I V+
) Y RG ( G I R T -
) NRG ( G I R T +
Serial TX (YLW)
Serial RX (BLUE)
8
7
6
5
4
3
2
1
M12
DSA Power Mating Connections
:+7*51
*51
:+7251
251
:+7%51
%51
0 5-
6+,(/' 6+,(/'
:+7%/8
%/8
3,1
3,1
3,1
3,1
3,1
3,1
3,1
3,1
DSA Ethernet Mating Connections
Question and Answer IconNeed help?

Do you have a question about the Scanivalve DSA5000 and is the answer not in the manual?

Scanivalve DSA5000 Specifications

General IconGeneral
BrandScanivalve
ModelDSA5000
CategoryScanner
LanguageEnglish

Related product manuals