SCANMASKIN SCAN COMBIFLEX 800 PROPAN

Questions and Answers

S
shelby12Aug 9, 2025
What to do if SCANMASKIN SCAN COMBIFLEX 800 PROPAN engine turns over but won't start?
- J
  Jamie BerryAug 9, 2025
  If the engine turns over but doesn't start, several issues could be the cause. Here are a few things to check: * Ensure the fuel tank is properly connected; disconnect and reconnect it. * Verify the fuel tank isn't empty; refill or replace it if needed. * Check the spark plug and replace it if there's no fire. * Examine the engine oil pressure and fill to the correct level if it's low. * Inspect the oil pressure switch and replace it if faulty. * Make sure the emergency stop button is released.
C
crochaAug 15, 2025
Why is my SCANMASKIN SCAN COMBIFLEX 800 PROPAN Floor Machine engine losing power and emitting excessive exhaust?
- J
  Juan RamirezAug 15, 2025
  If your SCANMASKIN Floor Machine's engine is running with a loss of power or excessive exhaust fumes, it could be due to a restriction in the air cleaner, so service the air cleaner. Another potential cause is ignition system misfire, in which case you should check or replace the ignition coils.
S
Stephanie BarrettAug 19, 2025
How to fix a SCANMASKIN Floor Machine when the starter motor doesn't operate?
- A
  Alexandra PowellAug 20, 2025
  If the starter motor on your SCANMASKIN Floor Machine isn't working, the problem might be a weak or dead battery, so recharge or replace the battery. It could also be due to a faulty start key; in that case, check and replace the key/switch.
B
brett93Aug 25, 2025
What to do if SCANMASKIN SCAN COMBIFLEX 800 PROPAN Floor Machine engine is overheating?
- C
  Courtney AlvarezAug 26, 2025
  If your SCANMASKIN Floor Machine engine is running hot or overheating, it could be because the intake screen or bonnet filter is clogged, so clean the screen and/or bonnet filter. Another possible cause is clogged cooling fins.
J
Jared HodgesAug 29, 2025
Why does SCANMASKIN Floor Machine vibrate a lot?
- J
  jacksonkristopherAug 29, 2025
  If your SCANMASKIN Floor Machine vibrates a lot, it could be because the grinding speed is too high. Lower the speed to reduce the vibration.
K
Kimberly OrtizSep 4, 2025
What to do if SCANMASKIN SCAN COMBIFLEX 800 PROPAN Floor Machine tools are damaged?
- M
  Michael MurphySep 4, 2025
  If the tools on your SCANMASKIN Floor Machine are damaged, inspect the tools and change the tools if needed.

SCANMASKIN SCAN COMBIFLEX 800 PROPAN Specifications

General

Model	SCAN COMBIFLEX 800 PROPAN
Category	Floor Machine
Power Source	Propane
Working Width	800 mm
Dust Extraction	Yes
Applications	Concrete grinding, surface preparation
Engine Power	16 kW / 22 HP