EasyManua.ls Logo

SCC Quik Grip - User Manual

SCC Quik Grip
4 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
This product is intended for use on snow and ice
covered roads. As such, it is legal in every state
and province in North America, including those
where studded tires are prohibited.
Refer to page four of this booklet for important
information regarding the use of this product.
Truck LLink CChain
(Single)
Installation and Removal Instructions
Thank you for choosing
Quik GGrip
tire chains
.
Please read and follow the installation and usage
tips shown here. A few moments familiarizing
yourself with this product’s features will give you
the best service possible for safe winter driving.
*
*
Div. of Burns Bros. Inc.
P.O. Box 949
Clackamas, OR 97015-0949
A pproperly iinstalled cchain:
Important:
We strongly recommend
that the chains be fitted to the tire
prior to actual use to insure proper
fit. Tire sizes may vary because of
age, manufacturer, tread or type.
Please ensure that the following
points are correct when installing
your chains.
1. The chain should drape at least 3
inches over each side of the tire from
the edge of the tread toward the rim.
2. Check to make sure that you
have the correct size chains and
that there is enough clearance
between the chain and bodywork,
suspension and brake parts, etc.
3. The chains should be tightened
as snug as possible. Security Chain
also recommends the use of chain
tighteners (sometimes referred to as
chain spreaders). Smooth portion of
hooks should be against tire.
© Security Chain Co. Div of Burns Bros
Inc., Clackamas, OR 97015-0949
All rights reserved; no part may be
reproduced in any form or by any
means without written permission.
Question and Answer IconNeed help?

Do you have a question about the SCC Quik Grip and is the answer not in the manual?

Summary

Installation and Removal Instructions

Properly Installed Chain Guidance

Key points for ensuring correct chain fit, clearance, and tightening for safe winter driving.

Installation Steps

Prepare Vehicle and Chain

Park vehicle, set brake, lay out chains ensuring no twists and hooks face upward.

Position Chain on Tire

Drape chain over tire, ensuring hooks face upward to prevent tire damage.

Advance Vehicle

Drive vehicle forward a short distance to pass cross chains under the tire.

Fasten Inside Connector

Engage and tighten the inside connector securely behind the tire.

Fasten Outside Connector and Retighten

Secure the outside fastener, drive briefly, and retighten all connections for optimal tightness.

Chain Tighteners and Removal

Using Chain Tighteners

Recommendations for using chain tighteners to take up additional slack and ensure proper fit.

Chain Removal Procedure

Steps to safely remove tire chains after use, including inspection and cleaning.

Maximum Chain Life and Cautions

Usage Cautions

Warning about product wear, breakage due to misuse, and manufacturer liability.

Tips for Chain Longevity

Advice on avoiding high speeds, spinning tires, locking brakes, and proper post-use care.

SCC Quik Grip Specifications

General IconGeneral
BrandSCC
ModelQuik Grip
CategoryAutomobile Accessories
LanguageEnglish

Related product manuals