ATTENTION: Make sure the notches of the former t
onto the projections of the mince bowl.
* Place the cone onto the mixing rod.
* Turn the screw ring on the mince bowl until it is
properly fastened.
* Mount the mince bowl into the main body as bended
right and turn it anti-clockwise until it is locked and xed.
* Place the tray on the upper mouth of the mince bowl
and turn it on.
* Put the prepared kebbe mixture into the mince bowl
and push it into the mince bowl with meat pusher.
* Cut the outer layer of kebbe into the desired lengths.
pexpert.indd 31 11.07.2019 18:01
To Next Page
Loading...