Instruction Manual for Electrobloc EBL 99 L / EBL 99 L with OVP
4
Date: 04.04.2018 8110423 BA / EN
Outputs are exceptions:
F Floor light/step
F Heater
F Frost protection valve
F AES/compressor refrigerator
F Spare 4
These outputs are not disabled via the main switch of the IT ... /LT control
and display panel.
Please refer to the operating instructions of the IT ... /LT... control and
switch panel for further information. .
3.2 Changing the battery
Y ATTENTION!
Use of incorrect battery types or incorrectly rated batteries.
Damage to the battery or devices connected to the electrobloc:
F Batteries should only be changed by qualified personnel.
F Follow the battery manufacturer’s instructions.
F Only connect the electrobloc to 12V power supplies with rechargeable
6-cell lead gel or lead acid batteries. Do not use any unsuitable bat-
tery types.
Y Normally only batteries of the same type and capacity should be used,
i.e. same as those installed by the manufacturer.
Y It is possible to swap lead acid batteries with lead gel batteries. However,
swapping from lead-gel-batteries to lead-acid-batteries is only possible in
certain cases. Contact the vehicle manufacturer for more information.
Electrically isolate the battery from the electrobloc by disabling the bat-
tery cut-off switch on the electrobloc (also see Section 3.4).
Replace battery.
After changing the battery, recheck which type of battery has been inser-
ted.
Y DANGER!
Incorrect setting of the battery selector switch.
Risk of explosion due to build up of explosive gases:
F Set the battery selector switch to the correct position.
Disconnect the electrobloc from the mains before adjusting the battery
selector switch.
1
Fig. 1 Battery selector switch
Changing the battery
To Next Page
Loading...
