EasyManua.ls Logo

Schell POLAR II - Operating Instructions

Schell POLAR II
24 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Bedienungshinweise/Bedieningsinstructies
Consignes dutilisation/Operating instructions
1. Zum Schließen, Armatur immer bis Anschlag zudrehen
(Wasser muss auslaufen). Armatureninhalt entleert sich
durch automatische Belüftung nach Schließvorgang.
2. Bei unter Druck stehendem angeschlossenen Schlauch
erfolgt ein Überdruckabbau vom Schlauch über die
Belüftungsöffnung der Armatur. Achtung: Armatur
und Schlauch entleeren nicht vollständig.
3. Vor Beginn der Frostperiode sind alle Schläuche und
etwaige anderen Anschlüsse zu entfernen. Armatur
immer bis Anschlag zudrehen (Wasser muss auslaufen).
1. Om te sluiten de armatuur altijd tot aan de aanslag
dichtdraaien (water moet uitlopen). Inhoud van de
armatuur wordt leeggemaakt door automatische
beluchting na het sluiten.
2. Bij onder druk staande aangesloten slang wordt de
overdruk van de slang afgebouwd via de beluchtingso-
pening van de armatuur. Opgelet: Armatuur en slang
worden niet volledig leeggemaakt.
3. Vóór het begin van de vorstperiode moeten alle slangen
en eventuele andere aansluitingen verwijderd worden.
Armatuur altijd tot aan de aanslag dichtdraaien (water
moet uitlopen).
1. Pour fermer, tourner toujours le robinet jusquau point
de butée (leau doit sévacuer). Le contenu du robinet
se vide par aération automatique après sa fermeture.
2. Pour les tuyaux sous pression raccordés, la surpression
est évacuée du tuyau par louverture daération du
robinet. Attention : Le robinet et le tuyau ne se vident
pas totalement.
3. Avant le début de la période de gel, retirer tous les
tuyaux et autres raccords éventuels. Tourner toujours le
robinet jusquau point de butée (leau doit sévacuer).
1. Always close the tap to the stop point (3/4 rotation
after water stop, water must flow out). Tap contents
empty after closing by automatic aeration.
2. The excess pressure is released from the hose through
the aeration opening in the fitting in the event of a
connected pressurised hose. Attention: The fitting and
hose do not empty completely.
3. Before the frost season, remove all hoses and any
other connections. Always close the fitting to the stop
point (water must flow out).
6
1
2
3
O
F
G
D
All manuals and user guides at all-guides.com
all-guides.com

Related product manuals