16
instructed in safe use of the device and know the risks involved. Cleaning and
maintenance must not be carried out by children unless they are supervised�
Children must not be allowed to play with the roller shutter drive.
CE DECLARATION AND CONFORMITY
The belt winder (Item no
DE
22755, 22725
) meets the applicable require-
ments of European and national regulations. Conformity has been demonstrated.
The full EU Declaration of Conformity document can be found at:
http://www.schellenberg.de (under ‘Download-Center’, in the ‘Service’ tab).
Do not dispose of together with household waste� The product is recyc-
lable and can be deposited at a recycling center or a collection station
for electrical household garbage�
INTENDED USE
This product
(Item no�
DE
22755, 22725
)
is intended exclusively for the
operation of belt-driven roller shutter systems. For this, the roller shutter system
must comply with the technical requirements of the product�
Any other or further utilization beyond the explicitly specied shall be regarded
as not intended use�
Alfred Schellenberg GmbH shall not be liable for any consequential damage,
property damage and personal injury due to improper use�
According to EN 13659, it must be ensured that the displacement requirements
as per EN 12045 are met for the hanging material� When unrolled, the displace-
ment at the lower edge must be at least 40 mm at an upward-directed force of
150 N� It must be ensured that the travel speed of the hanging must be less than
0�2 m/s in the last 0�4 m�
The roller shutter system and its parts must be in a perfect condition� Defects in
the system or its parts must be repaired before installing the product�
An easily accessible 230 V / 50 Hz mains socket outlet must be available at the
place of installation (see page 218).
The installation surface where the product is to be installed must be level and suitable�
Only use original spare parts to avoid product malfunction or defects�
Improper running of the belt (belt guiding) may destroy the shutter belt and cause
unnecessary strain on the product� Install the product such that the belt enters
the shutter belt drive as vertically as possible� This will avoid unnecessary fric-
tion and wear�
Machinery Directive
2006/42/EC
EMC Directive
2014/42/EU
RoHS Directive
2011/65/EU
To Next Page
Loading...
Need help?
General
