www.scheppach.com service@scheppach.com +(49)-08223-4002-99 +(49)-08223-4002-58
www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
21 І GB
Possible causes of failure
Troubleshooting Cause Remedy
Device does not work
No electrical voltage at the device.
Check the fuse, power cable and
power plug and have them replaced
by qualied personnel if necessary.
Cross section of the extension cable
not large enough and/or the exten-
sion cable is too long.
Use extension cables with larger
cross sections and/or use shorter
extension cables.
The mains voltage is lower than that
specied.
Contact the power supply company if
necessary.
The pump is frozen. Check and thaw if necessary.
The motor starts but there is no build
up of pressure
Air intake in the water inlet.
Check the supply hose and hose
connection and replace if necessary.
Discharge nozzle is too large. Check and replace if necessary.
Irregular operating pressure Air intake in the water inlet.
Check the supply hose and hose
connection and replace if necessary.
To Next Page
Loading...
Need help?
General
