www.scheppach.com
16
|
GB
These values for noise emissions are equip-
ment-based characteristic values and do not reect
the noise generated at the place of use. The noise
generated at the place of use will depend, for exam-
ple, on the work area, the workpiece, workpiece sup-
port and the number of stapling/nailing operations.
The value given for vibration is an equipmentbased
characteristic value and does not represent the impact
on the hand and arm system when the equipment is
used. The impact on the hand and arm system when
the equipment is used will depend, for example, on
the force of the grip, the pressing force, the direction
in which you are working, the air pressure setting, the
workpiece and the workpiece support.
Reduce noise generation and vibration to a min-
imum!
• Use only equipment that is in perfect condition.
• Maintain and clean the equipment regularly.
• Adopt your way of working to the equipment.
• Do not overload the equipment.
• Have the equipment checked if necessary.
• Switch o the equipment when not in use.
• Wear gloves.
Compressed air quality:
Puried and with oil mist.
Air supply:
Via a conditioning unit with lter pressure reducer and
mist oiler connected to a compressed air source.
Remember:
Wear the necessary protective clothing when
working with the stapler, in particular safety gog-
gles.
7. Preparing the product for use
NOTE: always wear the protective goggles supplied
before putting the tool into operation. Remove the pro-
tective lm from the protective goggles before using for
the rst time.
Connecting the compressed air source
NOTE: The compressed air tacker must only be oper-
ated with cleaned, oil-misted compressed air and must
not exceed the maximum operating pressure of 7.5 bar.
The compressor must be tted with a pressure reducer
in order to regulate the operating pressure.
• For you own personal safety, always use suitable
protective equipment such as, for example, hearing
and eye protection.
• Check that the trigger catch functions correctly
every time before you use the equipment. You are
allowed to start using the equipment only if the de-
vice functions perfectly.
This equipment is not suitable for the following work:
• If changing from one stapling point to another in-
volves moving about on platforms, steps, ladders
or any other structures similar to ladders such as,
e.g. roof battens.
• Sealing of boxes or crates.
• Fitting of transportation braces, e.g. to vehicles and
wagons
Do not lose this safety information.
Residual risks
Even if you use this tool in accordance with instruc-
tions, certain residual risks cannot be eliminated. The
following hazards may arise in connection with the
equipment’s construction and layout:
1. Risk of pinching.
2. Risk of injury from staples.
3. Damage to hearing, if no suitable ear protection
is applied.
4. Health damage caused by hand-arm vibrations,
if the equipment is not properly guided and main-
tained.
6. Technical data
Max. permitted operating pressure 8.3 bar
Recommended pressure range 4.7-7.5 bar
Air consumption 1.5 l
Staple width 5.7 mm
Staple length 16-40 mm
Nail length 15-50 mm
Recommended hose diameter 10 mm
Weight 1.2 kg
Sound pressure level L
pA
85.6 dB(A)
Sound power level L
WA
98.6 dB(A)
Vibration 2.01 m/s
2
To Next Page
Loading...
Need help?
General
