Why does my Scheppach Saw motor overheat easily?
Your Scheppach Saw motor may overheat due to overloading or insufficient cooling. To resolve this, avoid overloading the motor while cutting and ensure you remove dust from the motor to allow for optimal cooling.
What to do if my Scheppach Saw motor does not work?
If the Scheppach Saw motor isn't working, the motor, cable, or plug could be defective, or the fuses might be burnt. Check the fuses and replace them if necessary. Arrange for inspection of the machine by a specialist. Never repair the motor yourself, as it is dangerous!
Why is my Scheppach Saw cut rough or wavy?
A rough or wavy cut from your Scheppach Saw is likely due to a dull saw blade or a tooth shape that isn't appropriate for the material thickness. Re-sharpen the saw blade, or use a more suitable blade for the material you're cutting.
Why does my Scheppach BLMS216 Saw motor not reach its full power?
The Scheppach Saw motor might not reach full power if the circuits in the network are overloaded by other equipment or motors. Avoid using other equipment or motors on the same circuit.
What to do if the workpiece pulls away or splinters when using my Scheppach BLMS216?
If the workpiece pulls away or splinters while using the Scheppach Saw, it could be due to excessive cutting pressure or an unsuitable saw blade. Try reducing the cutting pressure and insert a suitable saw blade.
Why does the Scheppach BLMS216 motor make excessive noise?
If the Scheppach Saw motor is making excessive noise, it could be due to damaged coils or a defective motor. Arrange for inspection of the motor by a specialist.
Why does the Scheppach BLMS216 Saw motor start up slowly?
If the Scheppach Saw motor starts slowly and doesn't reach operating speed, the voltage may be too low, the coils could be damaged, or the capacitor might be burnt. Contact the utility provider to check the voltage. Arrange for inspection of the motor by a specialist. Arrange for replacement of the capacitor by a specialist.
To Next Page
General