What to do if my Scheppach Basa 3 motor does not start?
If your Scheppach Saw motor isn't starting, first, check the mains fuse. The issue might be due to a fastening nut tightened insufficiently or a defect in the extension cable. In case the connections on the motor or switch are defective, or the motor or switch itself is faulty, have it checked by an electrician.
What to do if my Scheppach Basa 3 motor turns off automatically?
If your Scheppach Saw motor turns off automatically, it might be overloaded by a dull saw. Insert a sharpened saw blade, then the motor can be turned on again. Another possibility is using the wrong saw blade; make sure to select a saw band according to the instructions.
Why does the saw band clamp when working with my Scheppach Basa 3 Saw?
If the saw band clamps when working with your Scheppach Saw, it could be due to several reasons. The saw band might be blunt, in which case you should replace it. Alternatively, it could be resinified, so clean the saw band. Also, check the saw band guidance according to instructions.
Why does my Scheppach Basa 3 Saw motor run forward or backwards?
If your Scheppach Saw motor runs forward or backward, the capacitor may be defective. Have it exchanged by an electrician.
Why does my Scheppach Basa 3 leave burns on the cutting surface?
If the cutting surface is burning when using your Scheppach Saw, it could be due to a fastening nut tightened insufficiently or using the wrong saw blade. To resolve this, insert a sharpened saw blade and select the correct saw band according to the instructions.
What to do if no motor output turns off automatically on Scheppach Basa 3?
If the Scheppach Saw motor stops automatically without any output, this could be due to an overload caused by a dull saw blade or using the wrong saw blade. Try inserting a sharpened saw blade, and ensure you select the saw band according to the instructions. After these steps, the motor can be turned on again.
General| Type | Band Saw |
|---|---|
| Motor | Induction motor |
| Saw Blade Length | 2240 mm |
| Blade Length | 2240 mm |
| Table Size | 548 x 400 mm |
| Table Tilt | 0° - 45° |
| Cutting Speed | 370 - 800 m/min |
| Blade Width | 6 - 20 mm |
To Next Page