What to do if my Scheppach Saw motor will not work, the fuse is active?
If your Scheppach Saw motor isn't working but the fuse is active, it might be because: * The cross section of the extension cable is not sufficient: Consult the „Electrical connection“ section for correct specifications. * There's an overload caused by a blunt saw blade: Change the saw blade to a sharp one.
How to fix a Scheppach Saw blade that dissolves after switching off the engine?
If the blade of your Scheppach Saw dissolves after switching off the engine, it may be due to a slightly tightened fastening nut. To resolve this, tighten the right hand thread nut.
Why won't my Scheppach Saw engine start?
There are several reasons why your Scheppach Saw engine might not be starting: * A blown mains fuse: Check the mains fuse and replace if necessary. * A defective extension cable: Replace the extension cord with a functioning one. * Disorderly connections on the motor or switch: Have an electrical specialist repair the connections. * A faulty motor or switch: Have an electrical specialist repair the motor or switch.
What to do if my Scheppach HS80 leaves fire marks on the cutting surface?
If you notice fire marks on the cutting surface while using your Scheppach Saw, it could be due to: * A blunt saw blade: Sharpen the saw blade (only by an authorised sharpening specialist) or replace it. * A wrong saw blade: Replace the saw blade with the correct one.
How to fix Scheppach Saw blade dissolving after switching off the engine?
If the blade of your Scheppach Saw dissolves after switching off the engine, try tightening the right hand thread nut.
What to do if my Scheppach Saw motor won't work but the fuse is active?
If your Scheppach Saw motor isn't working but the fuse is still active, this could be because the cross section of the extension cable is not sufficient, refer to „Electrical connection“. Another potential cause is overload by a blunt saw blade, in which case you should change the saw blade.
Symbol indicating danger to life, injury, or damage.
Risk of injury! Never reach into the running saw blade.
Read all warnings, instructions, and save for future reference.
Proper use of guards, riving knife, hand placement, and workpiece guidance.
Understanding and preventing kickback with safety instructions.
Safety measures for operation, setup, and securing the saw.
Adjusting the riving knife and replacing the saw blade.
General cutting advice and performing rip cuts.
General| Power | 1200 W |
|---|---|
| Blade Diameter | 210 mm |
| Cutting Depth at 90° | 48 mm |
| Cutting Depth at 45° | 45 mm |
| No-load Speed | 4800 rpm |
| Table Size | 525 x 400 mm |
| Saw Blade Bore | 30 mm |
| Motor | Induction motor |
To Next Page
