How to fix a loose saw blade on a Scheppach Saw?
If the saw blade gets loose after turning off the motor of your Scheppach Saw, it's likely that the fastening nut wasn't tightened sufficiently. Ensure you tighten the fastening nut, remembering it's an M20 left-handed thread.
Why Scheppach HS410 Saw motor does not start?
If your Scheppach Saw's motor isn't starting, there are several potential causes. First, check the mains fuse to ensure it hasn't failed. If the fuse is fine, inspect the extension cable for any defects and replace it if necessary. Finally, the connections on the motor or switch may be defective, or the motor or switch itself could be faulty. In these cases, it's best to have an electrician check it out.
What to do if there are burns on the cutting surface with Scheppach Saw?
If you notice burns on the cutting surface when using your Scheppach Saw, it's likely due to a dull or incorrect saw blade. Try inserting a sharpened saw blade. If the issue persists, make sure you are using the correct saw blade for the material you are cutting.
What to do if Scheppach HS410 has no motor output and turns off automatically?
If your Scheppach Saw experiences no motor output and turns off automatically, the issue could stem from a couple of factors. One possibility is that the cross-section of your extension cable is too low, refer to the "electric connection" section for details. Another cause could be overload due to a dull saw blade. Try inserting a sharpened saw blade to resolve this.
Why Scheppach HS410 has wrong rotational direction?
If your Scheppach Saw is running in the wrong rotational direction, it could be due to a capacitor defect, which should be checked by an electrician. Another possible cause is a changed phase, in which case you should have the polarity of the wall socket changed by an electrician.
Detailed steps for assembling the machine components and parts.
Checks and procedures to perform before operating the machine.
Step-by-step guide on how to perform sawing operations safely and correctly.
Instructions for safely replacing the saw blade on the machine.
General| Idle speed | - RPM |
|---|---|
| Product color | Black, Blue, Grey |
| Placement supported | Freestanding |
| Input power | 2200 W |
| AC input voltage | 230 V |
| Saw blade included | Yes |
Weight and Dimensions| Depth | 1080 mm |
|---|---|
| Width | 780 mm |
| Height | 250 mm |
| Weight | 43600 g |
| Blade diameter | 405 mm |
To Next Page
