Scheppach HS410 User Manual

www.scheppach.com
32
|
GB
17. Troubleshooting
The table below contains a list of error symptoms and explains what you can do to solve the problem if your tool
fails to work properly. If the problem persists after working through the list, please contact your nearest service
workshop.
Problem Possible cause Help
Saw blade gets loose after
turning o󰀨 the motor
Fastening nut tightened insu󰀩ciently
Tighten fastening nut, M20 left-handed
thread
Motor does not start
Failure main fuse Check the mains fuse.
Extension cable defect Replace the extension cable
Connections on the motor or switch
defect
Have it checked by an electrician
Motor or switch defect Have it checked by an electrician
Wrong rotational direction
Capacitor defect Have it checked by an electrician
Changed phase
Have the polarity of the wall socket
changed by an electrician
No motor output, turns o󰀨
automatically
Cross section of extension cable is
too low
See "electric connection"
Overload by dull saw blade Insert a sharpened saw blade
Burns on the cutting
surface
Dull saw blade Insert a sharpened saw blade
Wrong saw blade Insert correct saw blade
Improper handling of waste equipment may have neg-
ative consequences for the environment and human
health due to potentially hazardous substances that
are often contained in electrical and electronic equip-
ment. By properly disposing of this product, you are al-
so contributing to the e󰀨ective use of natural resourc-
es. You can obtain information on collection points for
waste equipment from your municipal administration,
public waste disposal authority, an authorised body for
the disposal of waste electrical and electronic equip-
ment or your waste disposal company.
Old devices must not be disposed of with house-
hold waste!
This symbol indicates that this product must
not be disposed of together with domestic
waste in compliance with the Directive
(2012/19/EU) pertaining to waste electrical
and electronic equipment (WEEE). This product must
be disposed of at a designated collection point. This
can occur, for example, by handing it in at an author-
ised collecting point for the recycling of waste electri-
cal and electronic equipment.

Scheppach HS410 Specifications

General

Idle speed	- RPM
Product color	Black, Blue, Grey
Placement supported	Freestanding
Input power	2200 W
AC input voltage	230 V
Saw blade included	Yes

Weight and Dimensions

Depth	1080 mm
Width	780 mm
Height	250 mm
Weight	43600 g
Blade diameter	405 mm