www.scheppach.com
GB
|
29
Other general occupational health and safety-related
rules and regulations must be observed.
m IMPORTANT
When using the equipment, a few safety precau-
tions must be observed to avoid injuries and damage.
Please read the complete operating instructions and
safety regulations with due care. Keep this manual
in a safe place, so that the information is available at
all times. If you give the equipment to any other per-
son, hand over these operating instructions and safety
regulations as well. We cannot accept any liability for
damage or accidents which arise due to a failure to
follow these instructions and the safety instructions.
The manufacturer shall not be liable for any changes
made to the machine nor for any damage resulting
from such changes.
Despite use as intended, specic risk factors cannot
be entirely eliminated. Due to the design and layout of
the machine, the following risks remain:
• Contact with the saw blade in the exposed sawing
area
• Reaching into the running saw blade (cutting injury)
• Kick-back of workpieces and workpiece parts
• Saw blade breakage
• Ejection of faulty carbide parts of the saw blade
• Hearing damage when the necessary hearing pro-
tection is not used
• Harmful emissions of wood dusts during use in en-
closed areas
Please note that our equipment has not been designed
for use in commercial, trade or industrial applications.
Our warranty will be voided if the equipment is used
in commercial, trade or industrial businesses or for
equivalent purposes.
5. Safety information
General power tool safety warnings
m WARNING: Read all safety warnings, instruc-
tions, illustrations and technical data provided
with this power tool. Failure to follow the warnings
and instructions may result in electric shock, re and/
or serious injury.
Save all warnings and instructions for future ref-
erence.
33. Fixing screw (riving knife)
34. Screw (saw blade cover)
35. Saw blade cover
36. Suction port
37. Groove (stop rail)
38. Scale
39. Groove (stop rail)
40. Groove (saw table)
41. Mains cable
3. Scope of delivery
• Saw blade guard
• Push stick
• Parallel stop
• Transverse stop
• Table width extension
• End pieces and screws for table width extension
• Assembly material
• Ring spanner, 19/10 mm
• Ring spanner, 7/8 mm
• Operating manual
4. Intended use
The circular table saw is used for the longitudinal and
transverse cutting (only with the transverse stop) of
all types of timbers and plastic, in accordance with
the machine size. It is not permitted to cut any type
of round timber.
The equipment is allowed to be used only for its pre-
scribed purpose. Any other use is deemed to be a case
of misuse. The user/operator and not the manufactur-
er will be liable for any damage or injuries of any kind
resulting from such misuse.
The machine is to be operated only with suitable saw
blades. (HM or CV saw blades). The use of any type of
HSS saw blades and cutting discs is prohibited.
An element of the intended use is also the observance
of the safety instructions, as well as the assembly in-
structions and operating information in the operating
manual.
Persons who operate and maintain the machine must
be familiar with the manual and must be informed about
potential dangers.
In addition, the applicable accident prevention regula-
tions must be strictly observed.
To Next Page
Loading...
Need help?
General
